Sony HAP-Z1ES User Manual page 101

5. Select [Yes] or [No].
6. Select one of the connection methods below:
If there is an IR input jack on the amplifier, connect the IR REMOTE OUT jack of the
HDD AUDIO PLAYER and the IR input jack of the amplifier with the monaural mini-plug
cable (supplied).
If there is no IR input jack on the amplifier, connect the plug of the supplied IR blaster
(supplied) to the IR REMOTE OUT jack of the HDD AUDIO PLAYER, and place the
other side of the IR blaster (the side to radiate infrared) close to the remote sensor of
the amplifier.
7. Select [Next].
8. Select the remote code of the connected amplifier.
If you are using a Sony 2ch amplifier, select [2ch Amplifier].
If you are using a Sony AV amplifier, select [AV Receiver 1] or [AV Receiver 2]
according to the remote code configured for the AV amplifier.
If you do not know which remote code should be set for your AV amplifier, select [AV
Receiver 2] at first and confirm whether IR signal is output. If the AV amplifier does not
work, select [AV Receiver 1]. Refer to the operating manual of the AV amplifier for
details.
A list of settings appears.
9. Select a setting you want to configure.
10. Select [In use].
Select [Not in use] for items you do not want to set.
11. Select [Next].
12. Select [Test].
Select [Exit] if you do not want to test.
13. Confirm the instructions on the screen and then select [Start].
The connection test starts.
14. When you have confirmed that no problems have been found in the test, select [Exit].
Note
If the HDD AUDIO PLAYER is turned off or in standby mode, you cannot adjust the volume
or mute the amplifier using the remote control supplied with the HDD AUDIO PLAYER.
Hint
You can also configure settings so that they are not controlled by the remote control, such as