Monitor; Speakers - Phonic Powerprod 1080 User Manual

CONNECTIONS
12

MONITOR

Other than the SPEAKERS output 13 , there is
this unbalanced 1/4" TS socket for sending line
signal to external amplifier or to another loca-
tion for monitoring or effect processing pur-
poses. Signal to this socket is taken out before
it goes to the built-in amplifier but after it has
gone through the built-in 7-band equalizer 27 .
You may take advantage of these output points:
1) When built-in power amplifiers do not provide
enough power for your needs.
2) When there is a remote location where user
would like to send content to.
See Figure 1 for unbalanced connection.
13

SPEAKERS

Located at the rear panel, there are unbalanced
1/4" TS phone sockets used to connect speak-
ers to the PowerPod rated at 4 ohms or greater.
PowerPod 1080 comes with 7 sockets while
P o w e r P o d 1 0 8 2 o n l y c o m e s w i t h 5 .
PowerPod 1080, users can use the SPEAKERS
Page 8
L, BRIDGE, R for front-of-the-house speakers
a n d t h e M O N I T O R f o r s t a g e m o n i t o r s .
PowerPod 1082 users can use the SPEAKERS
L, MONO, BRIDGE, R for front-of-the-house
speakers or R/MONITOR for stage monitors.
When in bridge mode, make sure the load is no
less than 8 ohms. Also make sure that nothing
is connected to the L and R channels of the out-
put
speakers share one output channel, the imped-
ance will become 4 ohms. Thus, when a pair of
speakers is connected to two output of the L
channel, or to the A and B output of MONITOR,
the built-in amplifier' s load will lower from the
8-ohm default to 4 ohms. Do not connect any-
thing to the BRIDGE output when the bridged
feature is not in use.
W i t h
POWERPOD1080/1082 USER' S MANUAL
13 . Generally speaking, when two 8-ohm
PHONIC CORPORATION