Instant Setup - Phonic Powerprod 1080 User Manual

INSTANT SETUP

Suppose you have one microphone, an elec-
tronic guitar and an electronic keyboard. Fol-
lowing these instructions to quickly set up your
system:
1. Turn down all LEVEL knobs 19 to the mini-
mal level; position all EQ knobs to the " 0" ;
turn the MAIN and the MONITOR level con-
trols 31 30 to the minimal level; have +48
Phantom Power off; position all the sliders of
the 7-band EQ at the " 0" position.
2. Connections:
A) Connect main speaker(s) to the L and R
output located in the rear panel.
B) Connect the microphone to the Lo-Z low
impedance input of channel 1
C) Connect the guitar to the Hi-Z high imped-
ance input of channel 2 and press down
t he PA D but t on or c on n e ct t he gu it a r
through a direct box to the Lo-Z low im-
pedance input of channel 2.
PHONIC CORPORATION
3. Have the Amplification Mode 34 of PowerPod
4. Turn on the power. Make sure to turn on
5. Turn the master level controls of MAIN L/R
6. Turn the LEVEL knob of channel 1, 2 and 7
7. Pay attention to the MASTER level meters;
8. Adjust the 3-band EQ of each input channel
9. You may turn on the EFFECT adding digital
POWERPOD1080/1082 USER' S MANUAL
D) Connect keyboard to the L-Line-R of chan-
nel 7.
E) Plug the unit' s power cord to a power
source.
1080 or of PowerPod 1082 set at STEREO.
Phantom Power when condenser microphone
is in use.
clockwise to the 12 o' clock position.
clockwise to the desired position.
make sure all the +6 LED don' t stay lit all the
time.
and 7-band EQ to the desired positions.
effect to MAIN L/R output.
INSTANT SETUP
Page 5