EdilKamin LOU Installation, Use And Maintenance Manual page 20

• ELECTRONIC EQUIPMENT
®
LEONARDO is a combustion safety and control system which allows optimal performance in all
conditions thanks to two sensors measuring the pressure level in the combustion chamber and smoke
temperature.
The detection of and subsequent optimisation of these two parameters is continuous in order to correct
operation anomalies in real time.
The LEONARDO ® system offers constant combustion, automatically regulating the draft based on the
characteristics of the chimney fl ue (bends, length, shape, diameter, etc.) and environmental conditions
(wind, humidity, atmospheric pressure, installations at high altitude, etc.).
The standards for installation must be respected.
®
The LEONARDO system is also able to recognise the type of pellets and automatically adjust the fl ow
moment by moment to ensure the required level of combustion.
• ELECTRONIC CIRCUIT BOARD
SERIAL PORT
The Dealer can install an optional on the AUX outlet for controlling the process of
switching on and off (e.g. telephone remote, local thermostat), located at the rear of the
stove. This can be connected via special optional trestle (code 640560).
BACKUP BATTERY
A backup battery is found on the control board (3-Volt CR 2032 battery). Its malfun-
ction is indicated with the following messages (not considered a defect but due to
normal wear-and-tear): "Battery check". For more detailed information, please contact
the DEALER who performed the fi rst 1st ignition.
FUSE *
Two fuses are inserted in the socket with switch, located on the back of the stove, one
of which operational * and the other is held in reserve **.
CHARACTERISTICS
Emergency button
RPM ambient
Control panel
remote-control
device
Lithium
CR2032
backup
battery
RES safety
tank
micro-port
TM 80°C
Smoke-expulsion motor
Tank
SCREW
ventilation ambient
- 20
-
Vacuum gauge
Reading points
Vacuum gauge
thermocouple
230 vac power
supply
50hz +/-10%
Port on back of stove
* **