Table of Contents
Advertisement
Setup
Note: Determine the left and right sides of the vehicle from the normal operating position.
Loose Parts
Note: Use the chart below to verify that all parts have been shipped.
Description
1
Charger
Key
Supervisor Speed Limit Switch Key
Operator's Manual
Operator Video
Parts Catalog
Registration Card
Predelivery Inspection Form
1
Refer to the Parts Manual for the available power cords for the voltage used in the region or country where operating the charger. Contact
your Authorized Toro Dealer to obtain the appropriate power cord.
Checking the Tire Pressure
Check the tire pressure every 8 hours or daily to ensure
proper levels.
The air pressure range in the front and rear tires is 8–22 psi
(55–152 kPa).
The air pressure needed is determined by the payload
carried. Lower air pressure will provide less compaction, a
smoother ride, and fewer tire marks. Lower pressure should
not be used for heavy payloads at high speeds.
Higher pressures should be used for heavier payloads at
higher speeds. Do not exceed the maximum pressure.
Setting the Charger Voltage
Important
The incorrect voltage setting on the battery
charger can impair function and damage the charger.
Always make sure the charger voltage setting matches the
voltage used to power the charger.
1. Locate the voltage selector on the rear of the charger
(Fig. 2).
2. Adjust the voltage setting by moving the switch on the
voltage selector upward or downward to change the
voltage setting (Fig. 2).
The setting is displayed in the window above the selector.
Note: Use the 100V setting for voltages ranging from 100V
to 120V.
Qty.
Use
1
Setting the charger voltage.
2
Use in the On/Off switch.
2
Use in the supervisor speed limit switch.
1
Read before operating the vehicle.
1
Watch before operating the vehicle.
1
Use for ordering replacement parts.
1
Complete and return to Toro.
1
Complete and file in your customer history portfolio.
Always use the appropriate power cord for the power outlet
of the country or region charging will occur. Contact your
Authorized Toro Dealer to obtain the correct power cord if
necessary.
4
100-120 V
1. Voltage selector
2. Voltage setting window
3. Switch
12
2
1
240 V
220 V
200 V
3
Figure 2
Rear of charger
4. Voltages by switch
position
m–7914
Advertisement
Table of Contents
