Drive System Maintenance; Adjusting The Transmission For Neutral; Adjusting The Transport Speed - Toro 04510 Operator's Manual

Drive System
Maintenance
Adjusting the Transmission
for Neutral
If the machine creeps when the traction-control pedal is in
the N position, adjust the neutral-return mechanism.
EUTRAL
1. Block up under the frame so that one of the front
wheels is off of the floor.
Note: If machine is equipped with a 3-Wheel Drive
Kit, also raise and block rear wheel.
2. Start the engine, move the throttle to the S
position, and ensure that the front wheel that is off
of the floor is not rotating.
3. If the wheel is rotating, shut off the engine and proceed
as follows:
A. Loosen the nut securing the eccentric to the top
of the hydrostat
1
Figure 46
1. Eccentric
B. Move the functional-control lever to the N
position and the throttle to the S
Start the engine.
C. Rotate the eccentric until creep does not occur in
either direction. When the wheel stops rotating,
tighten the nut locking the eccentric and the
adjustment (Figure
with the throttle in the S
Note: If the wheel still turns when the eccentric
is at the maximum adjustment, contact your
Authorized Service Distributor or refer to the
Service Manual for further adjustment.
LOW
(Figure 46).
g014616
2. Locknut
EUTRAL
position.
LOW
46). Verify the adjustment
and F position.
LOW AST

Adjusting the Transport Speed

Obtaining the Maximum Transport
Speed
The traction pedal is adjusted for maximum-transport speed
at the factory, but you may need to adjust it if the pedal
reaches full stroke before it contacts the pedal stop, or if you
want to a decrease the transport speed.
To obtain the maximum-transport speed, put the functional
control lever in the T
the traction pedal. If the pedal contacts the stop
before you feel tension on the cable, perform the following
adjustment procedure:
1
2
1. Pedal stop
1. Put the functional-control lever in the T
position and loosen the locknut securing the pedal stop
to the floor plate
2. Tighten the pedal stop until it does not contact the
traction pedal.
3. Continue applying a light load on the transport pedal
and adjust the pedal stop so it contacts the pedal rod
and tighten the nuts.
Important: Ensure that the tension on the cable
is not excessive or you will reduce the cable life.
Reducing the Transport Speed
1. Press down on the traction pedal and loosen the
locknut securing the pedal stop to the floor plate.
2. Loosen the pedal stop until you obtain the desired
transport speed.
3. Tighten the locknut securing the pedal stop.
37
position and press down on
RANSPORT
Figure 47
(Figure 47).
(Figure 47)
g015494
RANSPORT