Setting The Reel Speed - Toro 04510 Operator's Manual

2. Push the motor retaining bar out of the slots on the
motor towards the cutting unit and remove the motor
from the cutting unit.
2
1
Figure 33
1. Reel motor
3. Move the motor to the storage location on the front of
the suspension arm
Figure 34
Note: When sharpening, setting the height-of-cut,
or performing other maintenance procedures on the
cutting units, store the cutting unit reel motors in the
storage location on the front of the suspension arms to
prevent damage to them.
Important: Do not raise the suspension to the
transport position when the reel motors are in the
holders in the machine frame. Damage to the
motors or hoses could result. If you must move the
traction unit without the cutting units installed,
secure them to the suspension arms using cable
ties.
4. Open the latches on the suspension-arm bar of the
cutting unit you are removing
5. Disconnect the latches from the cutting-unit bar.
6. Roll the cutting unit out from under the suspension
arm.
7. Repeat steps 2 through
as required.
g014605
2. Motor-retaining bar
(Figure 34).
(Figure 30).
6 for the other cutting units

Setting the Reel Speed

To achieve a consistent, high-quality cut and a uniform,
after-cut appearance, you must correctly set the reel speed
control (located on the manifold block under the cover to the
left of the seat). Adjust the reel speed control as follows:
1. Select the height-of-cut at which the cutting units are
set.
2. Choose the desired ground speed best suited for
conditions.
3. Using the appropriate graph (See
11, or 14 blade cutting units, determine the proper reel
speed setting.
4. To set the reel speed, rotate the knob
until the indicator arrows are in line with the number
g014608
designating desired setting.
1. Reel-speed control
Note: You can increase or decrease the reel speed to
compensate for turf conditions.
28
Figure 35) for 5, 8,
Figure 35
(Figure
Figure 36
g014736
36)
1
g014623