Toro 04510 Operator's Manual page 27

1
Figure 29
1. Footrest—closed
2. Position the cutting unit under the center suspension
arm.
3. With the latches on the suspension-arm bar pointing
up (i.e., open) (Figure
down so that the bar fits over the bar across the top of
the cutting unit (Figure
1
Figure 30
1. Latch—closed position
2. Suspension-arm bar
1
2
Figure 31
1. Suspension-arm bar
4. Close the latches down and around the cutting-unit bar
and lock them in place
2
2. Footrest—open
30), push the suspension arm
31).
2
3. Latch—open position
2. Cutting-unit bar
(Figure 30).
Note: A "click" can be heard and felt when the latches
are properly locked in place.
5. Coat the spline shaft of the cutting unit motor with
clean grease
6. Insert the motor into the left side of the cutting unit
(as viewed from the operator's position) and pull the
motor retaining bar on the cutting unit toward the
motor until you hear an audible "click" from both sides
g014602
of the motor
3
g014609
1. Reel motor
2. Spline shaft
7. Mount a grass basket onto the basket hooks on the
suspension arm.
8. Repeat this procedure for the other cutting units.
g01461 1
Removing the Cutting Units
1. Park the machine on a clean level surface, lower
the cutting units to the ground until the suspension
hydraulics are fully extended, stop the engine, and set
the parking brake.
27
(Figure 32).
(Figure 32).
2 3
1
Figure 32
3. Cavity
4. Motor-retaining bar
4
g014690