Connecting A Cd Player Or Turntable - Onkyo TX-SA706 Instruction Manual

Connecting the AV Receiver/AV Amplifier—Continued

Connecting a CD Player or Turntable

■ CD Player or Turntable (MM) with Built-in Phono Preamp
Step 1:
Choose a connection that matches your CD player ( ,
phono preamp.
b
a
Connect one
or the other
Connection
must be
b
assigned
(see page 44)
COAXIAL
OUT
• With connection , you can listen to and record audio from the CD player and listen in Zone 2.
a
• To connect the CD player digitally, use connection
, or and .)
b a c
Connection
a
DIGITAL COAXIAL IN 2 (VCR/DVR)
b
DIGITAL OPTICAL IN 2 (CD)
c
■ Turntable (MM) with no Phono Preamp Built-in
The AV receiver/AV amplifier's PHONO IN is designed for use
with a moving magnet (MM) type cartridge.
Use an analog audio cable to connect the AV receiver/AV
amplifier's PHONO IN L/R jacks to the audio output on your
turntable.
Notes:
• If your turntable has a ground wire, connect it to the AV
receiver/AV amplifier's GND screw. With some turntables,
connecting the ground wire may produce an audible hum.
If this happens, disconnect it.
• If your turntable has a moving coil (MC) type cartridge,
you'll need a commercially available MC head amp or MC
transformer. Connect your turntable to the head amp or trans-
former, and connect that to the AV receiver/AV amplifier's
PHONO IN L/R jacks.
• You can also use a phono equalizer to connect a turntable
with an MC-type cartridge. See your phono equalizer's man-
ual for details.
a
IN 2
(VCR/DVR)
COAXIAL
IN
L
R OPTICAL
CD IN 2
(CD)
c
L R
AUDIO OPTICAL
OUT OUT
AV receiver/AV amplifier
CD IN L/R
, or ). Use connection
b c
CD player
or . (To record or listen in Zone 2 as well, use
b c
Signal flow
⇐
Analog audio L/R output
⇐
Digital coaxial output
⇐
Digital optical output
for a turntable with a built-in
a
IN
L
R
AUDIO
CD
OUTPUT
a
Turntable (MM) with
built-in phono preamp
and
a
CD or turntable
AUDIO
OUTPUT
L
R
L
R
35