Onkyo TX-SA706 Instruction Manual page 50

First Time Setup—Continued
1 Turn on the AV receiver/AV
amplifier and the connected TV.
On the TV, select the input to which the
AV receiver/AV amplifier is connected.
2
Place the speaker setup micro-
phone at measurement point
(page 49), and connect it to the
SETUP MIC jack.
Notes:
• Before starting Audyssey MultEQ
Automatic Speaker Setup, arrange
the room and connect the speakers as
you would for enjoying movies.
Changes to the room after auto setup
requires you run the auto setup again,
as room EQ characteristics may have
changed.
• When starting the automatic speaker
setup, do not stand between the
speakers and microphone, and avoid
obstacles blocking the path between
speakers and microphone. This will
produce inaccurate results.
• Position the microphone at ear height
of a seated listener with the micro-
phone tip pointed directly at the ceil-
ing using a tripod. Do not hold the
microphone in your hand during
measurements as this will produce
innacurate results.
• Make the room as quiet as possible.
Background noise can disrupt the
room measurements. Close win-
dows, silence cell phones, televi-
sions, radios, air conditioners,
fluorescent lights, home appliances,
light dimmers, or other devices.
• Cell phones should be turned off or
placed away from all audio electron-
ics during the measurement process
as Radio Frequency Interference
(RFI) may cause measurement dis-
ruptions (even if the cell phone is not
in use).
50
Auto Speaker Setup
Please place microphone at center of listening
area at ear height.
Push Enter : Next
3
1
4
®
5
Press [ENTER].
The automatic speaker setup starts.
Auto Speaker Setup
Do not unplug Setup Mic.
Please keep quiet.
Now measuring. . .
Test tones are played through each
speaker as Audyssey MultEQ Auto-
matic Speaker Setup runs. This process
takes a few minutes. Please refrain
from talking during measurements and
do not stand between speakers and the
microphone.
The following screen appears.
Auto Speaker Setup
Please place microphone at
2nd Position at ear height.
Push Enter : Next
Place the setup microphone at
the next position (page 49), and
then press [ENTER].
Audyssey MultEQ performs more
measurements. This takes a few min-
utes.
Auto Speaker Setup
Do not unplug Setup Mic.
Please keep quiet.
Now measuring. . .
When prompted, place the setup
microphone at the next position,
and repeat step 4.