Onkyo TX-SA706 Instruction Manual page 74

Advanced Setup—Continued
5 Use the Up and Down [q]/[w] but-
tons to select "Front", and then
use the Left and Right [e]/[r]
buttons to select a crossover fre-
quency.
Note:
If the "Subwoofer" setting in step 4 is
set to
Band".
6 Use the Up and Down [q]/[w] but-
tons to select "Center", and then
use the Left and Right [e]/[r]
buttons to select a crossover fre-
quency.
If no center speaker is connected, select
"None".
Note:
If the
anything other than
Band"
7
Use the Up and Down [q]/[w] but-
tons to select "Surround", and
then use the Left and Right [e]/
[r] buttons to select a crossover
frequency.
If no surround left and right speakers
are connected, select "None".
Note:
If the
anything other than
Band"
74
, this setting is fixed at "Full
"No"
setting in step 5 is set to
"Front"
"Full Band"
cannot be selected here.
setting in step 5 is set to
"Front"
"Full Band"
cannot be selected here.
8
9
, "Full
,
"Full
Use the Up and Down [q]/[w] but-
tons to select "Surr Back", and
then use the Left and Right [e]/
[r] buttons to select a crossover
frequency.
If no surround back speakers are con-
nected, select "None".
Notes:
• If the "Surround" setting in step 7 is
set to "None", this setting cannot be
selected.
• If the "Surround" setting in step 7 is
set to anything other than "Full
Band", "Full Band" cannot be
selected here.
• If the "Speakers Type" setting is set
to "Bi-Amp" (page 45), or Powered
Zone 2 is being used (page 98), this
setting cannot be selected.
Use the Up and Down [q]/[w] but-
tons to select "Surr Back Ch",
and then use the Left and Right
[e]/[r] buttons to select:
1ch: Select if one surround back
speaker is connected.
2ch: Select if two (left and right)
surround back speakers are
connected.
Note:
If the Surr Back Setting in step 8 is
" "
set to , this setting cannot be
"None"
selected.
Continue with step 10 on the next page.