Onkyo HT-R960 Instruction Manual page 43

First Time Setup—Continued
2 On the SKW-960 Subwoofer, set
the OUTPUT LEVEL control to
Subwoofer's
"THX POSITION."
rear panel
3
Place the speaker setup micro-
phone at measurement point 1
(page 42), and connect it to the
SETUP MIC jack.
Please place microphone at center
Notes:
• Before starting Audyssey 2EQ
Automatic Speaker Setup, arrange
the room and connect the speakers as
you would for enjoying movies.
Changes to the room after auto setup
requires you run the auto setup again,
as room EQ characteristics may have
changed.
• When starting the automatic speaker
setup, do not stand between the
speakers and microphone, and avoid
obstacles blocking the path between
speakers and microphone. This will
produce inaccurate results.
• Position the microphone at ear height
of a seated listener with the micro-
phone tip pointed directly at the ceil-
ing using a tripod. Do not hold the
microphone in your hand during
measurements as this will produce
inaccurate results.
• Make the room as quiet as possible.
Background noise can disrupt the
room measurements. Close win-
dows, silence cell phones, televi-
sions, radios, air conditioners,
fluorescent lights, home appliances,
light dimmers, or other devices.
• Cell phones should be turned off or
placed away from all audio electron-
ics during the measurement process
as Radio Frequency Interference
(RFI) may cause measurement dis-
ruptions (even if the cell phone is not
in use).
Auto Speaker Setup
AUDYSSEY
of listening area at ear height.
Push Enter : Next
®
4 Press [ENTER].
The automatic speaker setup starts.
Do not unplug microphone.
Please keep quiet.
Now Measuring. . .
Test tones are played through each
speaker as Audyssey 2EQ Automatic
Speaker Setup runs. This process takes
a few minutes. Please refrain from
talking during measurements and do
not stand between speakers and the
microphone.
5 The following screen appears.
Please place microphone at right end
of listening area at ear height.
Move the speaker setup micro-
phone to measurement point 2
(page 42), then press [ENTER].
Audyssey 2EQ performs more mea-
surements. This takes a few minutes.
6 The following screen appears.
Please place microphone at left end
of listening area at ear height.
Move the speaker setup micro-
phone to measurement point 3
(page 42), then press [ENTER].
Audyssey 2EQ performs more mea-
surements. This takes a few minutes.
Auto Speaker Setup
AUDYSSEY
Auto Speaker Setup
AUDYSSEY
Push Enter : Next
Auto Speaker Setup
AUDYSSEY
Push Enter : Next
43