Crankshaft Assembly - Kubota Z482-E2B Workshop Manual

SM-E2B SERIES, WSM

Crankshaft Assembly

For Z482-E2B, D662-E2B, D722-E2B
1. Remove the main bearing case screw 2 (1).
2. Draw out all the crankshaft.
For Z602-E2B
1. Remove the main bearing case screw 2 (1).
2. Turn the crankshaft to set the crankpin of the cylinder to the
horizontal directions (right or left).
crankshaft, holding the crankpins to the horizontal directions.
For D782-E2B, D902-E2B
1. Remove the main bearing case screw 2 (1).
2. Turn the crankshaft to set the crankpin of the third cylinder to the
bottom dead center. Then draw out the crankshaft until the
crankpin of the second cylinder comes to the center of the third
cylinder.
3. Turn the crankshaft by 2.09 rad (120 °) counterclockwise to set
the crankpin of the second cylinder to the bottom dead center.
Draw out the crankshaft until the crankpin of the first cylinder
comes to the center of the third cylinder.
4. Repeat the above steps to draw out all the crankshaft.
(When reassembling)
• Clean the oil passage of the crankshaft with compressed air.
• Install the crankshaft assembly, aligning the screw hole of main
bearing case screw 2 with the screw hole of crankcase.
• When tightening the main bearing case 2, apply oil to the main
bearing case screw 2 (1) and screw by hand before tightening the
specific torque. If not smooth to screw by hand, align the screw
holes between the crankcase and the main bearing case.
Tightening torque Main bearing case screw 2
(1) Main Bearing Case Screw 2
A : Cut place for removing and
installing the crankshaft
(D782-E2B, D902-E2B)
S-46
DIESEL ENGINE
Then draw out all the
26.5 to 30.4 N·m
2.7 to 3.1 kgf·m
19.5 to 22.4 ft-lbs
[a] Z482-E2B, D602-E2B
[b] D662-E2B, D722-E2B,
D782-E2B, D902-E2B
[c] D782-E2B, D902-E2B
W1031360
KiSC issued 06, 2006 A