Table of Contents
Advertisement
Figure 10
Note: The gap should be approximately the thickness
of a pencil (6 mm or 1/4 inch). If it is greater, loosen
the cable clamp nut, slide the cable jacket up slightly,
tighten the cable clamp nut, and check the gap again.
6. Repeat steps 2 through 5 for the other cable.
3
Installing the Traction-Control
Linkage
No Parts Required
Procedure
1. Remove the hairpin cotter and washer from the lower
end of the speed-control rod and insert the lower end
of the rod into the lower link arm so that the bent end
of the speed-control rod faces rearward
2. Secure the lower end of the speed-control rod with the
washer and hairpin cotter that you previously removed.
3. Remove the hairpin cotter and the outer washer from
the trunnion on the upper end of the speed-control
rod
(Figure
12).
(Figure
Figure 11
1. Speed-selector lever
2. Trunnion
Note: To make installation easier, leave the flat washer
on the trunnion
4. Shift the speed-selector lever into Position R2.
5. Rotate the lower link arm fully upward
(counterclockwise) as shown in
11).
6. Lift up the speed-control rod and insert the trunnion
into the hole in the speed-selector lever
Note: If the trunnion does not fit into the hole
when you lift up on the speed-control rod, rotate the
trunnion upward or downward on the speed-control
rod until it fits.
7. Secure the trunnion and upper end of the speed control
rod with the outer washer and the hairpin cotter that
you previously removed.
7
Figure 12
3. Inner washer
4. Outer washer
(Figure
12).
Figure
13.
Figure 13
(Figure
12).
Advertisement
Table of Contents
