Table of Contents
Advertisement
Figure 7
1. Wheel-clutch lever
3. Remove the nut and washer from the handle,
attach the cable clamp on the cable to the
handle, install the washer and the nut, and
tighten the nut by hand
Figure 8
1. Cable clamp (2)
Important:
Ensure that the curved side of
the cable clamp is against the handle and
that the cable is routed below the clamp bolt.
The cable must be in a straight line from the
cable clamp to the point where it attaches to
the wheel-clutch lever.
4. Pull the cable jacket down gently until the
wheel-clutch lever is down and the slack is out
of the cable, then tighten the cable-clamp nut
securely
(Figure
9).
Figure 9
5. Squeeze the lever fully, then check the gap
between the bottom of the handle and the end
of the wheel-clutch lever
g001303
(Figure
8).
g001304
g001305
(Figure
10).
Note:
The gap should be approximately the
thickness of a pencil (1/4 inch or 6 mm). If it is
greater, loosen the cable-clamp nut, slide the
cable jacket up slightly, tighten the cable-clamp
nut, and check the gap again.
6. Repeat steps 2 through 5 for the other cable.
3
Installing the
Traction-Control Linkage
No Parts Required
Procedure
1. Remove the hairpin cotter and washer from the
lower end of the speed-control rod and insert the
lower end of the rod into the lower link arm so
that the bent end of the speed-control rod faces
rearward
(Figure
2. Secure the lower end of the speed-control rod
with the washer and hairpin cotter that you
previously removed.
3. Remove the hairpin cotter and outer washer
from the trunnion on the upper end of the
speed-control rod
7
Figure 10
11).
Figure 11
(Figure
12).
g001306
g000985
Advertisement
Table of Contents
