Displaying And Deleting Measurements - Beurer BM 45 Instructions For Use Manual

Repeat the measurement if the flashing icon
after the measurement. Please note that you should rest for
5 minutes between measurements and not talk or move dur-
ing the measurement. If the icon
contact your doctor. Any self-diagnosis and treatment based
on the test results may be dangerous. It is vital to follow your
doctor's instructions.
Classification of measurements:
The measurements can be classified and evaluated in accord-
ance with the following table.
However, these standard values serve only as a general guide-
line, as the individual blood pressure varies in different people
and different age groups etc.
It is important to consult your doctor regularly for advice. Your
doctor will tell you your individual values for normal blood pres-
sure as well as the value above which your blood pressure is
classified as dangerous.
The bar chart on the display and the scale on the unit show
which category the recorded blood pressure values fall into.
If the values of systole and diastole fall into two different cate-
gories (e.g. systole in the High normal category and diastole in
the Normal category), the graphical classification on the device
always shows the higher category; for the example given this
would be High normal.
Blood pressure Systole
value category (in mmHg)
Setting 3: ≥ 180
severe hyper-
tension
is displayed
appears often, please
Diastole Action
(in mmHg)
≥ 110 seek medical
attention
Blood pressure Systole
value category (in mmHg)
Setting 2: 160 – 179 100 – 109
moderate hyper-
tension
Setting 1: 140 – 159 90 – 99
mild hyperten-
sion
High normal 130 – 139 85 – 89
Normal 120 – 129 80 – 84
Optimal < 120
Source: WHO, 1999 (World Health Organization)

7. Displaying and deleting measurements

The results of every successful measurement are stored
together with the date and time. If there are more than 60
measurements, the oldest measurements are lost.
• To access memory recall mode, the blood pressure
monitor must first be started. To do this press the Start/
stop button .
• Within 3 seconds of the full-screen display appearing,
select the desired user memory (
M2 memory button.
– To view the measurements for user memory , press
the M1 memory button.
23
Diastole Action
(in mmHg)
seek medical
attention
regular monito-
ring by doctor
regular monito-
ring by doctor
self-monitoring
< 80 self-monitoring
) with the M1 or