Displaying Source Information; Changing The Input Display - Onkyo HTX-22HDXPAW Instruction Manual

Playing Your Components

Displaying Source Information

You can display various information about
the current input source as follows.
Press the remote controller's [DISPLAY]
button repeatedly to cycle through the avail-
able information.
The following information can typically be
displayed:
Input source & volume
1
Signal format* or sampling frequency
Input source & listening mode
*1. If the input signal is analog, no format
information is displayed. If the input sig-
nal is PCM, the sampling frequency is
displayed. If the input signal is digital but
not PCM, the signal format is displayed.
Information is displayed for about 3 sec-
onds, then the previous display reappears.
30
—Continued

Changing the Input Display

You can change the input display so that it
shows the type of component connected to an
input when that input is selected. The input
display can be changed for the following
DISPLAY inputs: DIGITAL IN 1 (DIG1), DIGITAL
IN 2 (DIG2), DIGITAL IN 3 (DIG3),
LINE 1, and LINE 2.
1
Use HTX-22HDX's [INPUT] button to
select the input whose input display you
want to change.
2
Press and hold down the [INPUT] button
(about 3 seconds) to change the setting.
Below are the input display options for
each input:
DIG1: DIG1, DIG1(DOCK)
DIG2: DIG2, DIG2(DOCK), DIG2(TV)
DIG3: DIG3(TV), DIG3, DIG3(DOCK)
LINE1: LINE1, LINE1(DOCK),
LINE2: LINE2, LINE2(DOCK),
Example displays are shown below.
INPUT
STANDBY
HDMI Thru
LINE1(DVD), LINE1(CD),
LINE1(TAPE), LINE1(MD),
LINE1(CDR), LINE1(TV).
LINE2(DVD), LINE2(CD),
LINE2(TAPE), LINE2(MD),
LINE2(CDR), LINE2(TV).