Changing The Presser Foot; Removing And Attaching The Foot Holder - ELNA eXperience 580 Instruction Manual

q
w
e
r
q
w
e
w

Changing the Presser Foot

Always make sure to turn the power switch off before
replacing the presser foot.
Use the proper foot for the selected pattern.
The wrong foot can cause the needle to break.
Raise the needle to its highest position and raise the
presser foot lifter.
Press the red button on the back of the foot holder.
The presser foot will drop off.
q Red button
w Presser foot
Attaching the presser foot
t Place the presser foot so that the pin on the foot lies just
under the groove of the foot holder.
Lower the presser bar to lock the foot in place.
Each foot is marked with an identification letter.
e Groove
r Pin
t Identification letter

Removing and Attaching the Foot Holder

Always make sure to turn the power switch off before
replacing the foot holder.
Removing the foot holder
Raise the needle to its highest position and raise the
presser foot lifter.
Loosen the setscrew.
Remove the foot holder.
q Presser bar
w Foot holder
e Setscrew
Attaching the foot holder
q
Attach the foot holder to the presser bar from the rear.
Tighten the thumbscrew securely with the screwdriver.
e
13
CAUTION:
CAUTION: