ELNA eXperience 580 Instruction Manual page 35

v
b
n
m
i
o
!0
!1
!2
v Close the zipper and spread the fabric open flat with
the right side facing up.
Attach the Zigzag foot A.
Adjust the stitch length to 5.0, stitch width to 3.5 (default
value) and the thread tension dial to 1.
Baste the opened fabric and zipper tape together.
i Basting
o Zipper tape
b Attach the zipper foot E with the left pin.
Adjust the stitch length and the stitch width to default
value, and thread tension dial to "AUTO".
Backstitch across the end of the opening 0.7-1 cm
(3/8˝) and turn the fabric 90 degrees.
!0 0.7-1 cm (3/8˝)
CAUTION:
Be sure that the needle does not strike the presser
foot or zipper teeth when the zipper foot is attached.
n Stitch through the garment and zipper tape, guiding
the zipper teeth along the side edge of the foot.
Stop about 5 cm (2˝) from the top of the zipper.
Unfasten the basting stitches.
Lower the needle into the fabric, raise the foot, and
open the zipper.
!1 5 cm (2˝)
!2 Basting stitches
m Lower the foot and stitch the remainder of the seam,
making sure the fold is even.
Remove the basting threads after seaming.
33