Machine Operating Buttons - ELNA eXperience 580 Instruction Manual

q
q
y
w
e
r
t

Machine Operating Buttons

q Start/stop button
Press this button to start or stop the machine.
The machine starts running slowly for the first few
stitches, it then runs at the speed set by the speed control
slider. The machine runs slowly as long as this button is
t
pressed.
Pressing and holding this button while sewing will slow
down the sewing speed and the machine will stop when
r
the button is released.
e
NOTE:
• The start/stop button cannot be used when the foot
w
• The machine will not run and the presser foot mark
• You can select the desired start-up speed from
w Reverse button
• When stitch pattern 01, 04, 05, 10-12 (mode 1) or 56-
57 (mode 2) is selected;
The machine will sew in reverse as long as the
reverse button is pressed. Release the button to sew
forward.
When the machine is stopped and foot control is
disconnected, the machine will sew in reverse slowly
as long as the reverse button is pressed. Release the
button to stop the machine.
• When any other stitches are selected;
If you press the reverse button when sewing any other
patterns, the machine will immediately sew locking
stitches and automatically stop.
NOTE:
There will be particular functions of the reverse button
when pattern 02 , 03 , 31
Refer to page 29, 52 and 54 for instructions.
e Auto-lock button
• When stitch pattern 01, 04, 05, 10-12 (mode 1) or 56-
57 (mode 2) is selected;
Press the auto-lock button to sew a locking stitch
immediately. The machine will automatically stop.
• When any other stitches are selected;
Press the auto-lock button to sew a locking stitch
at the end of current pattern. The machine will
automatically stop.
The machine will trim the threads automatically after
locking the stitch when the auto thread cutting is
turned on (refer to page 67).
r Needle up/down button
Press this button to bring the needle bar up or down.
The machine will stop with the needle in down position.
However, you can change the needle stop position in the
machine setting mode (refer to page 24).
t Thread cutter button
After finish sewing, press this button to trim the threads.
The needle bar automatically rises after trimming the
threads (refer to page 27).
NOTE:
Use the thread cutter on the face cover if the thread is
#30 or thicker (refer to page 27).
8
control is connected to the machine.
y will blink if you start the presser foot in the up
position. Lower the presser foot and press the start/
stop button.
slow, medium or high (refer to page 24).
or 32 is selected.