Table of Contents
Advertisement
Electrical System
Maintenance
Important: Before welding on the machine, disconnect
both cables from the battery, both wire-harness plugs
from the electronic control module, and the terminal
connector from the alternator to prevent damage to the
electrical system.
Servicing the Battery
Service Interval: Every 50 hours—Check the condition of
and clean the battery.
Every 50 hours—Check the battery cable connections.
WARNING
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
DANGER
Battery electrolyte contains sulfuric acid which is a
deadly poison and causes severe burns.
• Do not drink electrolyte and avoid contact with
skin, eyes, or clothing. Wear safety glasses to
shield your eyes and rubber gloves to protect
your hands.
• Fill the battery where clean water is always
available for flushing the skin.
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks and
flames away from it.
Keep the terminals and the entire battery case clean because
a dirty battery will discharge slowly. To clean the battery,
wash the entire case with a solution of baking soda and water.
Rinse it with clear water.
Fuses
There are 8 fuses in the electrical system. The fuse block
(Figure
58) is located behind the control arm access panel.
1. Fuse block
42
Figure 58
Figure 59
Advertisement
Table of Contents
