Toro 03675 Operator's Manual page 14

Figure 9
1. Snapper pin
8. For the front cutting units, slide a cutting unit under
the lift arm while inserting the carrier-frame shaft up
into the lift-arm-pivot yoke
Figure 10
1. Lift arm
2. Carrier-frame shaft
9. Use the following procedure on the rear cutting units
when the height of cut is above 19 mm (3/4 inch).
A. Remove the lynch pin and washer securing the
lift-arm-pivot shaft to the lift arm and slide the
lift-arm-pivot shaft out of the lift arm
Figure 11
1. Lynch pin and washer
2. Cap
(Figure 10).
3. Lift-arm-pivot yoke
(Figure
B. Insert the lift-arm yoke onto the carrier-frame
shaft
C. Insert the lift-arm shaft into the lift arm and
secure it with the washer and lynch pin
11).
10. Insert the cap over the carrier-frame shaft and lift-arm
yoke.
11. Secure the cap and the carrier-frame shaft to the
lift-arm yoke with the snapper pin
Note: Use the slot if a steering cutting unit is desired
or use the hole if the cutting unit is to be locked in
position.
12. Secure the lift-arm chain to the chain bracket with the
snapper pin
Note: Use the number of chain links described in the
cutting unit Operator's Manual.
1. Lift-arm chain
2. Chain bracket
13. On cutting unit 4 (left front) and cutting unit 5 (right
front), insert the reel-motor hoses into the respective
hose guide.
14. Coat the spline shaft of the reel motor with clean
grease.
15. Oil the reel motor O-ring and install it onto the motor
flange.
16. Install the motor by rotating it clockwise so that the
motor flanges clear the bolts
11).
Note: Rotate the motor counterclockwise until the
flanges encircle the bolts then tighten the bolts.
Important: Make sure that the reel-motor hoses
are not twisted, kinked or in the risk of being
pinched.
14
(Figure 10).
(Figure
(Figure 12).
Figure 12
3. Snapper pin
(Figure
(Figure
9).
13).