Table of Contents
Advertisement
InfoCenter Revision
CAN Bus
Protected Menu
There are 5 operating configuration settings that are
adjustable within the Settings Menu of the InfoCenter: Blade
Count, Mow Speed, Height of Cut (HOC), F Reel RPM,
and R Reel RPM. These settings can be locked by using the
Protected Menu.
Note: At the time of delivery, the initial password code is
programmed by your distributor.
Accessing the Protected Menu Settings
1. From the Main Menu, scroll down to the Settings
Menu and press the right button.
2. In the Settings Menu, scroll down to the Protected
Menu and press the right button.
3. To enter the passcode, use the center button to set
the first digit then press the right button to move on
to the next digit.
4. Use the center button to set the second digit then press
the right button to move on to the next digit.
5. Use the center button to set the third digit then press
the right button to move on to the next digit.
6. Use the center button to set the fourth digit then press
the right button.
7. Press the middle button to enter the code.
8. If the code has been accepted and the protected menu
has been unlocked, "PIN" will be displayed in the
upper right corner of the display screen.
Note: If the passcode has been forgotten or misplaced,
please contact your distributor for assistance.
Viewing and Changing the Protected
Menu Settings
1. In the Protected Menu, scroll down to Protect Settings.
2. To view and change the settings without entering a
passcode, use the right button to change the Protect
Settings to O
.
FF
3. To view and change the settings with a passcode, use
the left button to change the Protect Settings to O
set the passcode, and turn the key in the ignition switch
to the O
position and then to the O
FF
Setting the Blade Count
1. In the Settings Menu, scroll down to Blade Count
Lists the software revision of
the InfoCenter.
Lists the machine
communication bus status.
N
position.
N
2. Press the right button to change the blade count
between 5, 8, or 11 blade reels.
Setting the Mow Speed
1. In the Settings Menu, scroll down to Mow Speed.
2. Press the right button to select mow speed.
3. Use the center and right button to select the appropriate
mow speed set on the mechanical mow-speed limiter
on the traction pedal.
4. Press the left button to exit mow speed and save the
setting.
Setting the Height of Cut (HOC)
1. In the Settings Menu, scroll down to HOC.
2. Press the right button to select HOC.
3. Use the center and right button to select the appropriate
HOC setting. (If the exact setting is not displayed,
select the nearest HOC setting from the list displayed).
4. Press the left button to exit HOC and save the setting.
Setting the Front and Rear Reel Speeds
Although the front and rear reel speeds are calculated by
inputting the number of blades, mow speed and HOC into
the InfoCenter, the setting can be manually changed to
accommodate for different mowing conditions.
1. To change the Reel Speed Settings, scroll down to the
F Reel RPM, R Reel RPM, or both.
2. Press the right button to change the reel speed value.
As you change the speed setting, the display continues
to show the calculated reel speed based on blade count,
mow speed and HOC, which was previously entered,
but the new value is also displayed.
,
22
Advertisement
Table of Contents
