Operation; Think Safety First; Checking The Engine-Oil Level - Toro 03675 Operator's Manual

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.
CAUTION
If you leave the key in the ignition switch, someone
could accidently start the engine and seriously
injure you or other bystanders.
Lower the cutting units to the ground, set the
parking brake and remove the key from the ignition
switch before servicing or making adjustments to
the machine.

Think Safety First

Carefully read all safety instructions and symbols in the
safety section. Knowing this information could help you or
bystanders avoid injury.
DANGER
Operating on wet grass or steep slopes can cause
sliding and loss of control.
Wheels dropping over edges can cause rollovers,
which may result in serious injury, death, or
drowning.
Read and follow the rollover protection instructions
and warnings.
To avoid loss of control and possibility of rollover:
• Do not operate near drop-offs or near water.
• Do not operate on slopes greater than specified
for your machine model.
• Reduce speed and use extreme caution on
slopes.
• Avoid sudden turns or rapid speed changes.
CAUTION
This machine produces sound levels that can cause
hearing loss through extended periods of exposure.
Wear hearing protection when operating this
machine.
The use of protective equipment for eyes, ears, hands, feet,
and head is recommended.
1
1. Wear eye protection.

Checking the Engine-Oil Level

Service Interval: Before each use or daily
The engine is shipped with oil in the crankcase; however, the
oil level must be checked before and after the engine is first
started.
Crankcase capacity: 5.2 L (5.5 US qt) with the filter
Use high-quality engine oil that meets the following
specifications:
•
API Classification Level Required: CH-4, CI-4 or higher
•
Preferred oil: SAE 15W-40 (above 0 degrees F)
•
Alternate oil: SAE 10W-30 or 5W-30 (all temperatures)
Toro Premium Engine oil is available from your distributor in
either 15W-40 or 10W-30 viscosity.
1. Park the machine on a level surface, stop the engine,
set the parking brake, and remove the key from the
ignition switch.
2. Open the hood.
3. Remove the dipstick, wipe it clean, and install it
28).
1. Dipstick
4. Remove dipstick and check the oil level on dipstick.
24
G009027
Figure 27
2. Wear hearing protection.
Figure 28
2
(Figure