Toro 03675 Operator's Manual page 13

The bolt head is to be positioned to the outer side
of the tab as shown in
Figure 5
1. Opposite carrier-frame tab
D. Mount the rod bracket to the cutting-unit tabs
with the carriage bolts and nuts
Important: On the #4 (left front) and #5
(right front) cutting units
the rod-bracket mounting nuts to install the
hose guides to the front of the cutting-unit
tabs (Figure 7). The hose guides should lean
toward the center cutting unit
Figure 8).
Figure 6
1
1. Hose guides must lean toward the center cutting unit.
Note: When installing or removing the cutting
units, make sure the hairpin cotter is installed
in the spring rod hole next to the rod bracket.
Otherwise, the hairpin cotter must be installed in
the hole in the end of the rod.
6. Lower all lift arms completely.
Figure 5.
2. Rod bracket
(Figure 5).
(Figure 6), use
(Figure 7 and
1. Hose guide (cutting unit 4
shown)
2. Rod bracket
Figure 8
7. Remove the snapper pin and the cap from the lift-arm
pivot yoke (Figure
13
Figure 7
3. Nut
1
9).
g019284