Onkyo DV DV-SP506 Instruction Manual page 63

Troubleshooting—Continued
Symptom
No sound?
The picture distorts occa-
sionally?
Picture instability or
noise?
Can't start playback?
Possible cause
No Sound from the HDMI OUT?
The HDMI Audio Out setting is set to Off.
The DV-SP506 is connected to the DVI jack
on your TV or AV receiver.
The HDMI setting on your TV or AV receiver
is set to DVI.
Your TV or AV receiver doesn't support Dolby
or DTS.
Your TV or AV receiver doesn't support
88.2 kHz, 96 kHz, 176.4 kHz or 196 kHz
PCM.
The HDMI Audio Out setting is set to 6ch
PCM or 6ch DSD, but your AV receiver or TV
does not support these formats.
No Digital Audio Output?
The HDMI Audio Out setting is set to Off.
Your TV or AV receiver doesn't support Dolby
or DTS.
Your TV or AV receiver doesn't support
88.2 kHz or 96 kHz PCM.
The SACD Audio Setup setting is set to DSD.
Your TV or AV receiver doesn't support DTS.
The source material is DTS and the Digital
Audio Out setting is set to PCM.
A DVD-Audio disc featuring 176.4 kHz or
192 kHz audio is being played.
The disc uses copy protection that prevents
audio being output by the digital outputs.
The disc is dirty.
You're using the Fast Forward or Fast Reverse
function.
The DV-SP506 is connected to your TV via a
VCR or other video equipment whose copy
protection system is affecting the picture.
No disc loaded.
The disc is incompatible.
The disc is upside down.
The disc is not centered in the disc tray.
The disc is dirty.
The disc supports parental lock and the Paren-
tal Lock function is on.
Remedy
Change the HDMI Audio Out setting to On
(page 51).
You won't hear any sound from the HDMI OUT if
your TV or AV receiver only supports DVI.
Change the HDMI setting on your TV or AV
receiver to HDMI.
Change the HDMI Audio Out setting to Auto or 2ch
PCM (page 51).
Change the Linear PCM Out setting to Down Sam-
ple On (page 51).
Set the HDMI Audio Out setting to Auto or 2ch
PCM (page 51).
Change the HDMI Audio Out setting to either Auto
or PCM (page 51).
Change the HDMI Audio Out setting to other than
Off (page 51).
Change the Linear PCM Out setting to Down Sam-
ple On (page 51).
Nothing is output by the OPTICAL and COAXIAL
outputs when DSD is selected. Change the SACD
Audio Setup setting to PCM (page 53).
The DV-SP506 will not be able to play DTS format
audio or soundtracks. On your DVD-Video disc's
audio setup menu, select an audio format other than
DTS.
When the Digital Audio Out setting is set to PCM,
DTS sources are not output by the digital audio out-
puts. Change the setting to ALL.
The OPTICAL and COAXIAL outputs cannot out-
put 176.4 kHz or 192 kHz audio. Set the Linear
PCM Out setting to Down Sample On.
Use another disc.
Remove the disc and clean it (page 10).
A little picture distortion may occur when using
these functions. This is normal.
Connect the DV-SP506 directly to your TV.
Load a disc (page 31).
Load only compatible discs (pages 8, 9).
Load the disc the correct way up (page 31).
Place the disc in the center of the disc tray
(page 31).
Remove the disc and clean it (page 10).
Turn off the Parental Lock function (page 56).
63