Connecting The Lift Arms To The Cutting Unit; Connecting The Pto Shaft To The Cutting Unit Gear Box - Toro 31335 Operator's Manual

1. Pivot pin
2. Lift arm
3. Pivot bracket
8. Install the wheel and tire assembly. Torque the wheel
nuts to 102-108 N-m (75-80 ft-lb).
9. Repeat the procedure on the opposite side of the
machine.
3
Connecting the Lift Arms to
the Cutting Unit
No Parts Required
Procedure
1. Remove the 2 thrust washers, clevis pin and hairpin
cotter from each castor arm bracket on the cutting
unit (Figure 4).
2. Move the cutting unit into position in front of the
traction unit.
3. Press the lift switch forward to the Float position. Push
a lift arm down until the holes in the lift arm line up
with the holes in the castor arm bracket
Figure 3
4. Brake return spring
5. Tab
(Figure
3
2
1
1. Castor arm bracket
2. Hairpin cotter
3. Clevis pin
4. Secure the lift arm to the castor arm with the 2 thrust
washers, clevis pin and hair pin cotter. Position the
thrust washers between the lift arm and the castor arm
bracket
in the castor arm tab to retain cotter pin.
5. Repeat the procedure on the opposite lift arm.
6. Start the traction unit and raise the cutting unit.
4
4).
Connecting the PTO Shaft to
the Cutting Unit Gear Box
No Parts Required
Procedure
1. Slide the male PTO shaft into the female PTO shaft.
Align the mounting holes in the gear case input shaft
with the holes in the PTO shaft and slide them together.
10
4
5
Figure 4
4. Lift arm
5. Thrust washer
(Figure 4). Insert end of cotter pin into the slot
g018216