Toro Mower Safety - Toro 31335 Operator's Manual

•
Never carry passengers and keep pets and bystanders
away.
•
Slow down and use caution when making turns and
crossing roads and sidewalks. Stop blades if not mowing.
•
Do not operate the mower under the influence of alcohol
or drugs.
•
Lightning can cause severe injury or death. If lightning
is seen or thunder is heard in the area, do not operate
the machine; seek shelter.
•
Use care when loading or unloading the machine into a
trailer or truck.
•
Use care when approaching blind corners, shrubs, trees,
or other objects that may obscure vision.
•
The operator shall turn on flashing warning lights, if
provided, whenever traveling on a public road, except
where such use is prohibited by law.
Maintenance and Storage
•
Disengage drives, lower the cutting units, move traction
pedal to Neutral, set parking brake, stop engine and
remove key. Wait for all movement to stop before
adjusting, cleaning or repairing.
•
Clean grass and debris from cutting units, drives, muffler.
Let engine cool before storing and do not store near
flames, and engine to help prevent fires. Clean up oil or
fuel spillage.
•
Let engine cool before storing and do not store near
flame.
•
Shut off fuel while storing or transporting. Do not store
fuel near flames or drain indoors.
•
Park machine on level ground. Never allow untrained
personnel to service machine.
•
Use jack stands to support components when required.
•
Carefully release pressure from components with stored
energy.
•
Disconnect battery before making any repairs. Disconnect
the negative terminal first and the positive last. Reconnect
positive first and negative last.
•
Use care when checking blades. Wrap the blades or
wear gloves, and use caution when servicing them. Only
replace blades. Never straighten or weld them.
•
Keep hands and feet away from moving parts. If possible,
do not make adjustments with the engine running.
•
Charge batteries in an open well ventilated area, away
from spark and flames. Unplug charger before connecting
or disconnecting from battery. Wear protective clothing
and use insulated tools.
•
Keep all parts in good working condition and all hardware
tightened. Replace all worn or damaged decals.
Hauling
•
Use care when loading or unloading the machine into a
trailer or truck.
•
Use full width ramps for loading machine into trailer or
truck.
•
Tie the machine down securely using straps, chains, cable,
or ropes. Both front and rear straps should be directed
down and outward from the machine. Make sure the
engine hood is securely strapped down.

Toro Mower Safety

The following list contains safety information specific to Toro
products or other safety information that you must know that
is not included in the CEN, ISO, or ANSI standard.
This product is capable of amputating hands and feet and
throwing objects. Always follow all safety instructions to
avoid serious injury or death.
Use of this product for purposes other than its intended use
could prove dangerous to user and bystanders.
•
Know how to stop the engine quickly.
•
Do not operate the machine while wearing tennis shoes
or sneakers.
•
Wearing safety shoes and long pants is advisable and
required by some local ordinances and insurance
regulations.
•
Handle fuel carefully. Wipe up any spills.
•
Check the safety interlock switches daily for proper
operation. If a switch should fail, replace the switch
before operating the machine.
•
Using the machine demands attention. To prevent loss
of control:
– Do not drive close to sand traps, ditches, creeks,
embankments, or other hazards.
– Avoid sudden stops and starts.
– When near or crossing roads, always yield the
right-of-way.
– Lower the cutting unit when going down slopes.
•
The grass deflector must always be installed and in the
lowest position on the side discharge cutting unit. Never
operate the mower without the deflector or entire grass
collector.
•
If the cutting unit discharge area ever plugs, shut the
engine off before removing the obstruction.
•
Cut grass slopes carefully. Do not start, stop, or turn
suddenly.
•
Do not touch the engine or muffler while the engine is
running or soon after it has stopped because these areas
could be hot enough to cause burns.
Maintenance and Storage
•
Check the blade mounting bolts frequently to be sure that
they are tightened to specification.
4