Adjusting The Rollers - Toro 31335 Operator's Manual

72in guardian recycler mower traction unit

Hide thumbs Also See for 31335:

Operator's manual (28 pages)

Table Of Contents

Table of Contents

Front Castor Wheels

1. Remove the tensioning cap from the spindle shaft

(Figure

7) and slide the spindle out of the castor arm.

Put the 2 shims (1/8 inch) onto the spindle shaft as

they were originally installed. These shims are required

to achieve a level across the entire width of the cutting

units. Slide the appropriate number of 1/2 inch spacers

onto the spindle shaft to get the desired height-of-cut;

then slide the washer onto the shaft.

Refer to

Figure 8

to determine the combinations of

spacers for the setting.

2. Push the castor spindle through the castor arm. Install

the shims (as they were originally installed) and the

remaining spacers onto the spindle shaft. Install the

tensioning cap to secure the assembly.

Note: When using 25 mm (1 inch), 38 mm (1-1/2

inch), or occasionally 51 mm (2 inch) height–of–cut,

move the skids and roller to the highest holes.

Rear Castor Wheels

1. Remove the tensioning cap from the spindle shaft

(Figure

9).

G018263

1. Tensioning cap

2. Shims

"C" Shaped spacers

Note: The rear castor fork assembly does not need

to be removed from the castor arm to change the

height-of-cut.

2. Remove or add "C" shaped spacers at the narrow

portion of the spindle shaft, below the castor arm, to

get the desired height-of-cut. Make sure that the shims,

not the spacers, contact the top and bottom of the

castor arm.

Figure 9

4. Castor Wheel

5. Axle mounting holes

3. Install the tensioning cap to secure the assembly.

4. Ensure that all four castor wheels are set at the same

height-of-cut.

Note: When using 25 mm (1 inch), 38 mm (1-1/2 inch), or

occasionally 51 mm (2 inch) height–of–cut, move the skids

and roller to the highest holes.