Table of Contents
Advertisement
7. Hook the brake return spring to the tab on the lift
arm (Figure 3).
1. Pivot pin
2. Lift arm
3. Pivot bracket
8. Install the wheel and tire assembly. Torque the wheel
nuts to 75-80 ft-lb (102-108 N-m).
9. Repeat the procedure on the opposite side of the
machine.
3
Connecting the Lift Arms to
the Cutting Unit
No Parts Required
Procedure
1. Remove the (2) thrust washers, clevis pin and hairpin
cotter from each castor arm bracket on the cutting
unit (Figure 4).
2. Move the cutting unit into position in front of the
traction unit.
3. Press the lift switch forward to the Float position.
Push a lift arm down until the holes in the lift arm
line up with the holes in the castor arm bracket
(Figure 4).
Figure 3
4. Brake return spring
5. Tab
4
3
2
1
1. Castor arm bracket
2. Hairpin cotter
3. Clevis pin
4. Secure the lift arm to the castor arm with the
(2) thrust washers, clevis pin and hair pin cotter.
Position the thrust washers between the lift arm
and the castor arm bracket (Figure 4). Insert end
of cotter pin into the slot in the castor arm tab to
retain cotter pin.
5. Repeat the procedure on the opposite lift arm.
6. Start the traction unit and raise the cutting unit.
4
Connecting the PTO Shaft to
the Cutting Unit Gear Box
No Parts Required
Procedure
1. Slide the male PTO shaft into the female PTO shaft.
Align the mounting holes in the gear case input
shaft with the holes in the PTO shaft and slide them
together.
11
5
g018216
Figure 4
4. Lift arm
5. Thrust washer
Advertisement
Table of Contents
