Connecting The Lift Arms To The Cutting Unit; (Cutting Unit Model 30366 Only) - Toro 30366 Operator's Manual

1. Pivot pin
2. Lift arm
3. Pivot bracket
6. Install the wheel and tire assembly. Torque the wheel
nuts to 75–80 ft-lb (102–108 N-m).
7. Repeat the procedure on the opposite side of the
machine.
3
Connecting the Lift Arms to
the Cutting Unit
Parts needed for this procedure:
1 Lift arm, right
1 Lift arm, left
4 Thrust washer-nylon
4 Clevis pin
2 Hair pin
2 Height of cut collar
2 Clevis pin
2 Hair pin
2 Capscrew, 1/2 x 3/4 inch
2 Washer
Procedure
1. Move the cutting unit into position in front of the
traction unit.
2. Move the lift lever to the Float position. Push a lift
arm down until the holes in the lift arm line up with
the holes in the castor arm bracket and the height
of cut rod can be inserted into the lift arm pads
(Figure 4).
Figure 3
4. Brake return spring
5. Tab
1. Lift arm
2. Castor arm bracket
3. Height-of-cut rod
4. Lift arm pads
5. Thrust washers
6. Clevis pin
3. Secure the lift arm to the castor arm with (2) thrust
washers, a clevis pin and a hair pin cotter. Position
the thrust washers between the lift arm and the
castor arm bracket (Figure 4). Insert end of cotter
pin into the slot in the castor arm tab to retain cotter
pin.
4. Repeat the procedure on the opposite lift arm.
5. Start the traction unit and raise the cutting unit.
6. Push down on the rear of the cutting unit and insert
the height of cut rods through the lift arm pads.
7. Install the height of cut collars onto the height of
cut rods and secure with the clevis pins and hair
pin cotters (Figure 4). Head of clevis pin to be
positioned toward the front of the deck.
8. Install a 1/2 x 3/4 inch bolt and a washer to top of
each height of cut rod (Figure 4).
10
Figure 4
7. Hairpin cotter
8. Height-of-cut collar
9. Clevis pin
10. Hairpin cotter
11. Bolt