Lubrication - Toro 31335 Operator's Manual

Lubrication

Service Interval: Every 50 hours
The machine has grease fittings that must be lubricated
regularly with No. 2 General-purpose Lithium-base Grease.
If the machine is operated under normal conditions, lubricate
all bearings and bushings after every 50 hours of operation or
immediately after every washing.
1. Lubricate the following areas:
•
Castor fork shaft bushings (4)
•
Spindle shaft bearings (3) (located under the pulley)
(Figure 20)
•
Idler arm shaft bearings
•
Lift arm pivots, front (2)
(Figure 19).
Figure 19
Figure 20
(Figure 20)
(Figure 21)
•
Lift arm pivots, rear (2)
2. Position the machine and cutting unit on a level surface
and lower the cutting unit. Remove the dipstick/fill
plug from the top of the gear box
sure that the lubricant is between the marks on the
dipstick. If the lubricant level is low, add SAE 80-90
wt. gear lube until the level is between the marks. The
gear box capacity is 283 ml (12 ounces).
1. Dipstick/fill plug
19
Figure 21
(Figure 22)
Figure 22
(Figure 23) and make
Figure 23