Setup Mode; Power On Functions - Printek PrintMaster 700 Series User Manual

4.2.4

Setup mode

In this mode, the following settings are available:
Adjust
Form Char
1 2 3 4
Access to the other menu settings (Form) may be disabled by the manufacturer.
Proceed as follows to release this lock temporarily.
1) Switch off the printer for approx. 5 seconds.
2) Switch the printer on again keeping the Setup key pressed.
4.2.5

Power on functions

If you keep one of the following keys pressed during power-on until the printer has completed
initialization, the corresponding function is activated:
If you keep the Online key depressed while turning on the printer, you enter the printer's
advanced menu mode. The advanced menu mode is described in the section
manual.
If you keep the Setup key depressed while turning on the printer, you regain access to the
printer menu if you had locked it before with the help of the Form Lock function.
If all four function keys (keys 1 to 4) are depressed simultaneously while turning on the
power, all printer settings are reset to the default values, except the Forml (Form length)
setting in advanced menu mode.
Holding Function key 4 while turning on the printer prints out the parameter settings.
Setup key: Sets the printer to setup mode, in which the
following settings can be selected.
Online
Form key (1): Other menu settings. Access may be
disabled by menu settings (see note below).
Setup
Adjust key (2): Sets the Tear position and first printing line
(TOF). If you have the PullTr (Pull - Tractor) selected Adjust
is not available.
Char key (4): Sets the font and the number of characters per
inch temporarily.
25
5.4.2 of this