Printek PrintMaster 700 Series User Manual page 58

2. Static assignment using the operator panel:
Press < Setup >, then < Form >
Press < Next > until the I/O selection appears. Select < I/O >.
Press < Next > until the ETH-INT selection appears. Select < ETH-INT >, then< IP Addr >
Enter the value for Octet 1by pressing < OCTET 1 >. Use the forward and backward
arrows to increment/decrement the number. When finished with each entry press
< Set > which will set the currently displayed value. To exit out without changing the value
press < Exit >. Enter the Octet 2 value in the same way, pressing < OCTET 2 >. To get to
Octet 3 and Octet 4, select < Next > and then select <OCTET 3> and < OCTET 4 >.
Enter the default Gateway and Subnet mask in the same way. < Gateway > is available
from the screen you are returned to. Press < Next > to select < Subnet >.
Enter the IP address get method under the selection <IP Get M>. Select <Static>.
3. BOOTP IP address assignment:
Press <Setup>, then <Form>
Press <Next> until the I/O selection appears. Select <I/O>.
Press <Next> until the ETH-INT selection appears. Select <ETH-INT>.
Press <Next> until the IP Get M selection appears. Select <IP Get M> Select <BOOTP>
Obtain the Ethernet MAC address by printing the "Current Settings" configuration page,
Turn off printer.
Configure your BOOTP server with desired IP address and MAC address.
Turn on printer.
Verify that the printer network interface received an IP address by printing the "Current
Settings" configuration page or in the operator panel menu.
.
.
49