Lubrication; Greasing The Traction Unit; Engine Maintenance; Servicing The Air Cleaner - Toro 22323 Operator's Manual

Lubrication

Greasing the Traction Unit

Service Interval: Before each use or daily (Grease
immediately after every washing.)
Grease Type: General-purpose grease.
1. Lower the loader arms and stop the engine. Remove
the key.
2. Clean the grease fittings with a rag.
3. Connect a grease gun to each fitting (Figure 31 and
Figure 32).
Figure 31
Figure 32
4. Pump grease into the fittings until grease begins to
ooze out of the bearings (approximately 3 pumps).
5. Wipe up any excess grease.

Engine Maintenance

Servicing the Air Cleaner

Service Interval: Before each use or daily—Check the air
filter service indicator.
Every 25 hours—Remove air cleaner cover, clean out
debris, and check the air filter service indicator.
Every 600 hours—Replace the safety air filter.
Servicing the Air Cleaner Cover and
Body
Important: Service the air cleaner filter only when the
service indicator shows red (Figure 33). Changing the
air filter before it is necessary only increases the chance
of dirt entering the engine when the filter is removed.
1. Lower the loader arms, stop the engine, and remove
the key.
2. Open the hood.
3. Check the air cleaner body for damage which could
cause an air leak.. Check the whole intake system for
leaks, damage, or loose hose clamps. Replace of repair
and damaged components.
4. Release the latches on the air cleaner and pull the air
cleaner cover off of the air cleaner body (Figure 33).
Important: Do not remove the air filters.
1 2
G009695
1. Air filter service indicator.
2. Air filter body
3. Safety filter
4. Primary filter
5. Squeeze the dust cap sides to open it and knock the
dust out.
6. Clean the inside of the air cleaner cover with
compressed air.
7. Check the air filter service indicator.
•
If the service indicator is clear, clean any debris
from cover and install cover.
29
3 4 5
7
Figure 33
5. Air cleaner cover
6. Latches
7. Dust cap
6