Sound Pressure; Sound Power; Safety And Instructional Decals - Toro 38597 Operator's Manual

• Do not wear loose-fitting clothing that could get
caught in moving parts.
• If a shield, safety device, or decal is damaged,
illegible, or lost, repair or replace it before beginning
operation. Also, tighten any loose fasteners.
• Do not smoke while handling gasoline.
• Do not use the snowthrower on a roof.
• Do not touch the engine while it is running or soon
after it has stopped because the engine may be hot
enough to cause a burn.
• Perform only those maintenance instructions
described in this manual. Before performing any
maintenance, service, or adjustment, stop the engine,
remove the key, and disconnect the wire from the
spark plug. If major repairs are ever needed, contact
an Authorized Service Dealer.
• Do not change the governor settings on the engine.
• When storing the snowthrower for more than 30
days, drain the fuel from the fuel tank to prevent
a potential hazard. Store fuel in an approved fuel

Safety and Instructional Decals

Important: Safety and instruction decals are located near areas of potential danger. Replace damaged
decals.
Reorder part no. 112-6631
1. Fast
2. Forward speeds
106-4525
3. Slow
4. Reverse speeds
container. Remove the key from the ignition switch
before storing the snowthrower.
• Purchase only genuine Toro replacement parts and
accessories.

Sound Pressure

This unit has a maximum sound pressure level at the
operator's ear of 86 dBA, based on measurements of
identical machines per EN 11201.

Sound Power

This unit has a guaranteed sound power level of 103
dBA, based on measurements of identical machines per
EN 3744.
Vibration
This unit does not exceed a hand/arm vibration level of
4.5 m/s 2 , based on measurements of identical machines
per EN 1033.
1. Cutting dismemberment, impeller and cutting
dismemberment, auger hazards—keep bystanders a safe
distance from the snowthrower.
4
107-3040