Sound Pressure; Sound Power; Safety/Instruction Decals - Toro CCR Powerlite 325 Operator's Manual

If a shield, safety device, or decal is damaged,
illegible, or lost, repair or replace it before
beginning operation. Also, tighten any loose
fasteners.
Do not smoke while handling gasoline.
Do not use the snowthrower on a roof.
Do not touch the engine while it is running or
soon after it has stopped because the engine
may be hot enough to cause a burn.
Perform only those maintenance instructions
described in this manual. Before performing any
maintenance, service, or adjustment, stop the
engine, remove the key, and disconnect the wire
from the spark plug. If major repairs are ever
needed, contact your Authorized Service Dealer.
Do not change the governor settings on the
engine.
When storing the snowthrower for more than 30
days, drain the fuel from the fuel tank to prevent a
potential hazard. Store fuel in an approved fuel
container. Remove the key from the ignition
switch before storing the snowthrower.

Safety/Instruction Decals

Important: Safety and instruction decals are located near areas of potential danger. Replace damaged decals.
94-2560
1. Cutting/dismemberment in
impeller hazard—stay
away from moving parts,
stop the engine, and
remove the key before
performing maintenance
94-2561
1. Hot surface/burn hazard—keep bystanders a safe distance from
the machine.
3
Purchase only genuine Toro replacement parts
and accessories.

Sound Pressure

This unit has a maximum sound pressure level at the
operator's ear of 90 dBA, based on measurements of
identical machines per Directive 98/37/EC.

Sound Power

This unit has a guaranteed sound power level of
107 dBA, based on measurements of identical
machines per Directive 2000/14/EC.
Vibration
This unit does not exceed a hand/arm vibration level
2
of 11.4 m/s , based on measurements of identical
machines per Directive 98/37/EC.
1. Cutting/dismemberment in
auger hazard—stay away
from moving parts, stop
the engine, and remove
the key before performing
maintenance
1. To engage the auger, hold the control bar against the handle.
2. To disengage the auger, release the control bar.
3327-915
94-2562
94-2577