Product Overview - Toro 38597 Operator's Manual

A. Release the traction lever and stop the engine.
B. Disconnect the trunnion from the speed selector
lever (Figure 6).
C. Turn the trunnion downward (clockwise) on the
speed control rod (Figure 6).
D. Connect the trunnion to the speed selector lever
(Figure 6).
4. Release the traction lever.
5. Move the speed selector to the Position 1; refer to
Operating the Speed Selector.
6. Squeeze the left hand (traction) lever to the hand-grip
(Figure 13).
The snowthrower should move forward. If the
snowthrower does not move or moves rearward,
complete the following:
A. Release the traction lever and stop the engine.
B. Disconnect the trunnion from the speed selector
lever (Figure 6).
C. Turn the trunnion upward (counterclockwise) on
the speed control rod (Figure 6).
D. Connect the trunnion to the speed selector lever
(Figure 6).
7. If you made any adjustments, repeat this procedure
until no adjustments are required.
Important: If the snowthrower moves when the
traction lever is in the released position, check the
traction cable (refer to Checking and Adjusting
the Traction Cable) or take the snowthrower to an
Authorized Service Dealer for service.

Product Overview

1. Hand-grip
2. Auger/impeller lever
3. Speed selector lever
4. Quick Stick™ discharge
chute control
5. Traction lever
6. Fuel tank cap
7. Engine oil fill tube/dipstick
1. Choke
2. Ignition switch
3. Fuel shutoff valve
4. Throttle
10
Figure 14
8. Chute deflector
9. Discharge chute
10. Scraper
11. Auger
12. Skid (2)
13. Snow cleanout tool
Figure 15
5. Recoil starter
6. Oil drain plug
7. Primer