Installing The Air Cleaner - Toro 74258 Operator's Manual

2
3
1
Figure 6
1. Filler caps
2. Upper line
4. Slowly pour electrolyte into each battery cell until the
level is up to the upper line (Fig. 6) on the battery
case.
Important Do not overfill the battery because
electrolyte (sulfuric acid) can cause severe corrosion and
damage to the chassis.
5. Wait five to ten minutes after filling the battery cells.
Add electrolyte, if necessary, until the electrolyte level
is up to the upper line (Fig. 6) on the battery case.
6. Reinstall battery filler caps.
Warning
Charging battery produces gasses that can
explode and cause serious injury.
Keep cigarettes, sparks and flames away from
battery.
Make sure the ignition switch is off.
Ventilate when charging or using battery in an
enclosed space.
7. Charge the battery. Refer to Charging the Battery on
page 49.
8. Install the battery into the machine. Refer to Installing
the Battery on page 48.
Note: Do not run the machine with the battery
disconnected, electrical damage may occur to the engine
computer.
Note: Do not jump start the machine.
m–5004
3. Lower line
19
Parts needed for this step:
1 Air Filter
1 Hose Clamp

Installing the Air Cleaner

1. Remove air cleaner from crate. Keep air cleaner and
bracket together. (Fig. 7).
2. Remove the top two valve cover mounting screws
from both valve covers (Fig. 7).
2
6
5
4
Figure 7
1. Air cleaner
2. Valve cover mounting
screws
3. Air cleaner bracket
3. Place air cleaner onto engine and align holes in air
cleaner bracket with holes in valve covers (Fig. 7).
4. Install valve cover screws into air cleaner bracket and
valve covers (Fig. 7).
Important Tighten the valve cover screws to 70 in–lb
(5 N m) torque.
5. Remove plastic plugs from air intake elbow on engine
and air cleaner hose (Fig. 7).
6. Install hose to air intake elbow on engine and air
cleaner. Tighten hose clamps to secure the hose
connections (Fig. 7).
1 2
3
m–4810
4. Air intake elbow
5. Air cleaner hose
6. Hose clamp