Servicing The Battery - Toro 74258 Operator's Manual

2. To replace fuses pull out on the fuse to remove it
(Fig. 59).
Figure 59
1. Main—30 amp
Fuse: Fuel Pump 10 amp, blade-type (Fig. 60)
Fuse: Engine Fuse 20 amp, blade-type (Fig. 60)
1. Locate fuses in the left rear of machine. Pull plastic
clip out and down to gain access to fuses in holders
(Fig. 60).
2. To replace fuses pull out on the fuse to remove it (Fig.
60).
1
Figure 60
1. Engine-20 amp
2. Fuel Pump-10 amp

Servicing the Battery

Warning
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. Wash hands after
handling.
Checking Electrolyte Level
1. With the engine off, locate the battery under the seat.
1
m–3653
2
3
m–4823
3. Plastic clip
47
2. Look at the side of the battery. The electrolyte must be
up to the upper line (Fig. 61). Do not allow the
electrolyte to get below the lower line (Fig. 61).
3. If the electrolyte is low, add the required amount of
distilled water; refer to Adding Water to the Battery,
page 49.
1
2
3
Figure 61
1. Filler caps
2. Upper line
Danger
Battery electrolyte contains sulfuric acid which is
a deadly poison and causes severe burns.
Do not drink electrolyte and avoid contact with
skin, eyes or clothing. Wear safety glasses to
shield your eyes and robber gloves to protect
your hands.
Fill the battery where clean water is always
available for flushing the skin.
Follow all instructions and comply with all
safety messages on the electrolyte container.
m–5004
3. Lower line