Replacing The Grass Deflector - Toro 74258 Operator's Manual

1
Figure 69
1. Fixed Idler
8. Check belt tension again. The center bolt of spring
loaded idler must be between the two alignment holes
in left support plate (Fig 68). Adjust, if necessary, and
tighten all hardware securely.
9. If the fixed idler contacts the end of the adjustment
slot and more belt tension is required, a small change
to lengthen the push arms can be made (Fig. 70).
10. To lengthen, loosen jam nut and rotate ball joint
counterclockwise, one turn at a time. Adjust each side
the same amount (Fig. 70).
3
1
Figure 70
1. Push arm
2. 15 inches (381 mm)
nominal
11. Rotate the belt guide, on rear of the mower, so it is
1/8–1/4 inch (3–7 mm) away from the vertical side of
the PTO belt (Fig. 71).
2
m–3746
2. Adjustment slot
4
2
m–6273
3. Jam nut
4. Ball joint
52
1
3
Figure 71
1. Belt guide
2. PTO drive belt

Replacing the Grass Deflector

Warning
An uncovered discharge opening could allow the
lawn mower to throw objects in the operator's or
bystander's direction and result in serious injury.
Also, contact with the blade could occur.
Never operate the lawn mower unless you install a
cover plate, a mulch plate, or a grass chute and
catcher.
1. Remove the locknut, bolt, spring and spacer holding
the deflector to the pivot brackets (Fig. 72). Remove
damaged or worn grass deflector.
2. Place spacer and spring onto grass deflector. Place the
L end of spring behind deck edge.
Note: Make sure the L end of spring is installed behind
deck edge before installing the bolt as shown in figure 72.
3. Install bolt and nut. Place J hook end of spring around
grass deflector (Fig. 72).
Important
The grass deflector must be able to lower
down into position. Lift the deflector up to test that it
lowers into the full down position.
2
M–4374
3. 1/8–1/4 inch (3–7 mm)