Table of Contents
Advertisement
6. Shut off the engine. Remove the jack stands and lower
the machine to the shop floor.
7. Test drive the machine to make sure it does not creep.
Adjusting the Rear Wheel
Toe-in
1. Rotate the steering wheel so that the rear wheels are
straight ahead.
2. Loosen the jam nut on each end of the tie rod
59).
Note: The end of the tie rod with the external groove
is a left hand thread.
Figure 59
1. Jam nut
2. Tie rod
3. Using the wrench slot, rotate the tie rod
4. Measure the distance at the front and rear of the rear
wheels at axle height. The distance at the front of the
rear wheels should be less than 6 mm (1/4 inch) of the
distance measured at the rear of the wheels.
5. Repeat procedure as required.
(Figure
3. Wrench slot
Cooling System
Maintenance
Removing Debris from the
Cooling System
1. Shut off the engine and remove the key from the
ignition switch.
2. Thoroughly clean all debris out of the engine area.
3. Unlatch the clamp and pivot open the rear screen
(Figure
60).
1. Rear-screen latch
4. Clean the screen thoroughly with compressed air.
5. Pivot the latches inward to release the oil cooler
61).
43
Figure 60
2. Rear screen
(Figure
Advertisement
Table of Contents
