Toro 03678 Operator's Manual page 14

Figure 5
1. Opposite carrier frame tab
D. Mount the rod bracket to the cutting unit tabs
with the carriage bolts and nuts
Important: On the #4 (left front) and #5
(right front) cutting units
the rod bracket mounting nuts to install the
hose guides to the front of the cutting unit
tabs (Figure 7). The hose guides should lean
toward the center cutting unit
Figure 8).
Note: When installing or removing the cutting
units, make sure that the hairpin cotter is installed
in the spring rod hole next to the rod bracket.
Otherwise, the hairpin cotter must be installed in
the hole in the end of the rod.
1
1. Hose guides (each must lean toward the center cutting unit)
2. Rod bracket
(Figure 5).
(Figure 6), use
(Figure 7 and
1. Hose guide (#4 cutting unit
shown)
2. Rod bracket
Figure 8
14
Figure 6
Figure 7
3. Nuts
1
g019284