Table of Contents
Advertisement
Figure 63
1. Measure blade at points A
and B
Changing the Deck
Front-to-Rear Pitch
Changing the front-to-rear pitch is done by
adjusting the front height-of-cut posts.
1. To change the front-to-rear pitch, the front
height-of-cut posts can be adjusted (Figure 64).
Figure 64
1. Caster Wheel
2. Carrier Frame
3. Front height-of-cut pins
2. To raise the front of the deck, loosen jam nut
and rotate the front pin clockwise (Figure 64).
2. Measure from a level
surface
4. Jam nut
5. Ball joint
3. To lower the front of the deck, loosen jam
nut and rotate the front pin counter clockwise
(Figure 64).
4. Position the blades front-to-rear. Measure at
C and D locations (Figure 63) from a level
surface to the cutting edge of the blades.
5. Check the side-to-side leveling of the cutting
unit.
6. Tighten the jam nuts (Figure 64).
Checking the Deck
Side-to-Side Leveling
1. Check the tire pressure on both deck and
traction unit.
2. Position the blades side-to-side (Figure 65).
Measure at B and C locations (Figure 65) from
a level surface to the cutting edge of blade tips
(Figure 65).
Figure 65
1. Measure from a level
surface
3. The difference between measurements B and
C should be no more than 1/4 inch (6 mm).
Changing the Side-to-Side
Leveling
Changing the side-to-side leveling is done by
adjusting tire pressure.
44
2. Measure blade at points B
and C
Advertisement
Table of Contents
