Table of Contents
Advertisement
1
2
3
4
5
6
7
9
Figure 14
1. 2 inch (51 mm) Cut
Height
2. 2-1/2 inch (64 mm) Cut
Height
3. 3 inch (76 mm) Cut
Height
4. 3-1/2 inch (89 mm) Cut
Height
Adjusting Gage Wheels
The gage wheels must be adjusted in the proper hole
location for each height-of-cut position.
1. After adjusting height-of-cut remove nut and washer
while holding stud with wrench (Fig. 15).
Note: Do not remove the wheel nut and washer (Fig. 15).
2. Select a hole position so the gage wheel is 3/8 inch (9.5
mm) off the ground for the height-of-cut to be used
(Fig. 15).
3. Reinstall the stud nut and washer (Fig. 15).
4. Repeat adjustment on other gage wheels.
8
m-2683
5. 4 inch (102 mm) Cut
Height
6. 4-1/2 inch (114 mm) Cut
Height
7. 5 inch (127 mm) Cut
Height
8. Clevis Pin
9. Hairpin Cotter
22
4
3
2
Figure 15
1. Gage Wheel
2. Stud
3. Washer
Adjusting Center Gage Wheels
The gage wheels must be adjusted in the proper hole
location for each height-of-cut position.
1. After adjusting height-of-cut remove bolt and nut
(Fig. 16).
2. Select a hole position so the gage wheel is 3/8 inch (9.5
mm) off the ground for the height-of-cut to be used
(Fig. 16).
3. Reinstall the bolt and nut (Fig. 16).
3
1
Figure 16
1. Center Gage Wheels
2. Nut
1
5
m–4123
4. Nut
5. Wheel nut and washer.
Do Not Remove.
2
m–4124
3. Bolt
Advertisement
Table of Contents
