Installing The Blade Control Bar; Installing The Handle; Filling The Engine With Oil - Toro 20333 Operator's Manual

Setup
Important: Remove and discard the protective
plastic sheet that covers the engine.
1. Installing the Blade Control
Bar
Procedure
Install the blade control bar into the upper handle
(Figure 3).

2. Installing the Handle

Procedure
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Remove the handle knobs from the mower housing
(Figure 4).
Important: Route the cables to the outside of
the handle knobs as you install the handle.
Figure 3
2. Move the handle to the operating position.
3. Install and tighten the handle knobs that you
removed in step 1 (Figure 4).

3. Filling the Engine with Oil

Procedure
Your mower does not come with oil in the engine, but it
does come with a bottle of oil.
1. Remove the dipstick (Figure 5).
1. Dipstick
2. Slowly pour oil into the oil fill tube until the oil level
reaches the Full line on the dipstick (Figure 5). Do
not overfill. (Max. fill: 20 oz. (0.59 l), type: SAE 30
5
Figure 4
Figure 5