Checking And Adjusting The Auger/Impeller Cable; Checking The Auger Gearbox Oil Level - Toro 38630 Operator's Manual

2
1
G001021
Figure 45
1. Jam nut
Checking and Adjusting the
Auger/Impeller Cable
Check and adjust the auger/impeller cable after the first
2 operating hours, then yearly thereafter.
1. Remove the 2 screws from the right side of the belt
cover as shown.
2. Lift up the right side of the belt cover (Figure 46).
Figure 46
3. With the auger/impeller lever disengaged, ensure that
the gap between the auger clutch assembly and the tab
is 1/16 inch (1.5 mm) (Figure 47).
1/16 inch (1.5 mm)
1
G001023
Figure 47
1. Tab
2. Turnbuckle
G001022
4. If the auger/impeller cable is not properly adjusted, do
the following steps:
5. Loosen the jam nut (Figure 48).
2
1
G001024
Figure 48
1. Jam nut
6. Loosen or tighten the turnbuckle that adjusts the
tension on the cable (Figure 48).
7. Adjust the turnbuckle until you obtain the proper gap.
8. Tighten the jam nut.
9. Insert the 2 screws you previously removed on the belt
cover.
10. If the auger/impeller cable is properly adjusted but a
problem remains, contact an Authorized Service Dealer.
Checking the Auger Gearbox
Oil Level
Check the auger gearbox oil yearly and add oil if necessary.
1. Move the snowthrower to a level surface.
2. Clean the area around the pipe plug (Figure 49).
Figure 49
3. Remove the pipe plug from the gearbox.
18
2. Turnbuckle
G001025