Preparing The Snowthrower For Storage - Toro 38630 Operator's Manual

Figure 58
3. Remove the bulb straight out from the back of the
headlight (Figure 59).
Figure 59
4. Insert a new bulb into the back of the headlight (Figure
60).
Figure 60
5. Turn the base of the bulb clockwise until it is snug
(Figure 61).
Figure 61
6. Insert the wire connector straight into the back of the
headlight until it is securely in place (Figure 62).
G001033
Storage
G001034
G001035
Preparing the Snowthrower
for Storage
1. On the last refueling of the year, add fuel stabilizer to
2. Run the engine for 10 minutes to distribute the
3. Loosen the hose clamp that secures the fuel line to the
4. Open the fuel shutoff valve and allow the fuel to drain
G001036
5. Install the fuel line onto the fuel shutoff valve and
6. Run the snowthrower until the engine stops from
7. Prime the engine and start it again.
8. Allow the engine to run until it stops. When you can no
9. Stop the engine and allow it to cool.
10. Remove the ignition key.
11. Disconnect the spark plug wire.
12. Remove the spark plug, add 1 oz. (30 ml) of oil through
21
1
G000992
Figure 62
•
Gasoline vapors can explode.
•
Do not store gasoline more than 30 days.
•
Do not store the snowthrower in an enclosure
near an open flame.
•
Allow the engine to cool before storing it.
fresh fuel as directed by the engine manufacturer.
conditioned fuel through the fuel system.
valve and slide the fuel line off the fuel shutoff valve.
out of the fuel tank into an approved fuel container.
secure it with a hose clamp.
running out of fuel.
longer start the engine, it is sufficiently dry.
the spark plug hole, and pull the starter rope slowly
3
2