Adjusting The Discharge Chute Latch; Replacing The Drive Belts; Replacing The Headlight Bulb - Toro 38630 Operator's Manual

Important: Do not clean the electrodes because
grit could enter the cylinder and damage the
engine.
4. Set the gap between the electrodes on the spark plug at
0.030 inch (0.76 mm) (Figure 53).
Figure 53
1. 0.030 inch (0.76 mm)
5. Install the spark plug by hand and then torque it to 15
ft-lb (20.4 N·m).
Note: If you do not have a torque wrench, tighten
the plug firmly.
Adjusting the Discharge Chute
Latch
If the discharge chute does not lock into the desired
position or does not unlock so that you can move it to
another position, adjust the discharge chute latch.
1. Remove the fastener on the gear cover (Figure 54), lift
the front of the cover up, and slide it back and out of
the way.
G001030
Figure 54
2. Loosen the bolt on the cable clamp (Figure 55).
Figure 55
1. Cable conduit
1
G001029
2
1
G001031
2. Cable clamp
3. Grasp the cable conduit and move it toward the front of
the machine until the discharge chute latch fully engages
the gear teeth (Figure 55 and Figure 56).
G001032
Figure 56
1. Discharge chute latch
Note: The latch is spring loaded and will naturally
move into the teeth of the gear (Figure 56).
4. Remove any slack in the cable by pulling the cable
conduit rearward.
5. Tighten the bolt on the cable clamp.
6. Install and secure the gear cover.

Replacing the Drive Belts

If the auger/impeller drive belt or the traction drive belt
becomes worn, oil-soaked, or otherwise damaged, go to
www.Toro.com for additional service information or have
an Authorized Service Dealer replace the belt.

Replacing the Headlight Bulb

Use a GE 892 16W halogen light bulb. Do not touch the
bulb with your hands or allow dirt or moisture to come into
contact with the bulb.
1. Remove the wire connector from the back of the
headlight (Figure 57).
Figure 57
2. Turn the base of the bulb counterclockwise until it
stops (Figure 58).
20
1
2
2. Gear teeth
G001037