1
Installing the Roll Bar
Parts needed for this procedure:
1
Roll bar
4
Bolt (1/2 x 3-3/4 inches)
4
Flange-nut (1/2 inch)
Procedure
1. Remove the top crate support from the crate.
2. Remove the roll bar from the crate.
3. Install the roll bar into the pockets on each side of
the machine, using 4 bolts (1/2 x 3-3/4 inches) and 4
flange-nuts (1/2 inch)
1. Roll bar
2. Bolt (1/2 x 3-3/4 inches)
4. Torque the fasteners to 136 to 149 N-m (100 to 110
ft-lb).
(Figure
3).
1
2
3
g014601
Figure 3
3. Flange-nut (1/2 inch)
2
Installing the Seat
Parts needed for this procedure:
1
Seat-completion kit
Procedure
Acquire your desired seat kit from your distributor and install
it as directed in the instruction included with the kit.
3
Installing the Steering Wheel
Parts needed for this procedure:
1
Steering wheel
1
Locknut (1-1/2 inches)
1
Washer
1
Steering wheel cap
Procedure
1. Slide the steering wheel onto the steering shaft
4).
1. Steering wheel
2. Washer
2. Slide the washer onto the steering shaft
3. Secure the steering wheel to the shaft with a locknut
and tighten it to 27 to 35 N-m (20 to 26 ft-lb)
4. Install the cap to the steering wheel and secure it with 6
bolts
(Figure
4).
13
Figure 4
3. Locknut
4. Cap
(Figure
(Figure
(Figure
4).
4).